| U型槽工艺流程 |
| 添加时间：2017/11/23 15:21:06 浏览次数： |
1.基面清理。
1. base plane cleaning.
2.批益胶泥、粘贴网格布。
The 2. batch of daub and paste mesh cloth.
3.弹线分格，贴泡沫胶带，泡沫胶带选择宽度1.5cm，厚度0.3cm左右。
3. elastic line partition, sticking foam tape, foam belt selection width 1.5cm, thickness about 0.3cm.
4.批刮第一道腻子，与胶带平齐，待腻子干后，撕去胶带。
The 4. batch of scraping the first putty, and tape flat, to be dried putty, tear tape.
5.在第一道腻子的基础上批第二道腻子，把缝批平，接着用直径1.5cm左右的PVC管沿着线槽拉出U型分割槽。
5. on the basis of the first putty, batch second putty, the seam leveling, and then use the diameter of about 1.5cm PVC tube along the line groove pull out U groove.
6.待腻子保养干透后，对U型槽修边打磨，上一道封闭底漆。
6. after putty maintenance, after drying, U groove trimming grinding, a closed primer.
7.封闭底漆干透后，画黑色或其他颜色的分格线专用漆。
7. special paint for black or other color dividing lines after sealing primer is dry.
8.将分格线用美纹纸保护好后，上有色底漆。
8. protect the color of the dividing line with the fine pattern paper.
9.有色底漆干透后，喷中涂主材2遍，及时撕去美纹纸。
9. colored primer is dry, spray coating material 2 times, timely tear textured paper. |
| 上一页 U型槽钢模具最新行情走势 |
| 下一页 U型槽模具市场的走向发展渠道 |
Copyright © 技术支持：遨游网络